Vidur's Blog: 2009

Friday, December 11, 2009

Check out these websites!

These are the websites. This is bikkanavalfamilynews.blogspot.com

This is tejasprak.blogspot.com

This is lalakerskobebryant.blogspot.com

This is vidurguptabloghindi.blogspot.com (It is in Hindi) (It’s my website) (Everything is same from this blog shown and the one you are reading from)

VIdUrquestions.blogspot.com Check that website also out. That is my website. I could not print screen.

Wednesday, December 9, 2009

How to make an Origami Sphinx

Instructions

Initial Steps

Step 1

Use a lightweight paper for making origami. Traditional origami paper is colored only on one side, but any paper of any color will do. Computer printer paper works fine.
Step 2

Cut your paper to size. Fold your paper in half diagonally, forming a triangle. Open the paper back up to a square. Fold your paper in half diagonally again, bringing the other two corners together. Open the paper back up.
Step 3

Fold the paper in half to make a rectangle and open it back up. Fold the paper in half the other way and open it back up. Fold two opposite sides of the square inward aligning the edges with the center crease to form a rectangle.
Step 4

Take one corner of the rectangle and fold it to form a triangle, aligning its edge along one long side of the rectangle. Then open it back up and fold the other corner next to it. Next open it back up until you have an X of creases.
Step 5

Put your fingers under the flaps of paper you just finished "X"ing and pull the corners outward until they form a canoe shape. Fold into the canoe shape, aligning the top edges.
Step 6

Take one lower corner of the canoe shape and fold it from the bottom middle of the canoe shape to the wide end point of the top of the canoe shape, forming a small triangle, and crease well. Do the same for the other side.

More Advanced Steps
Step 1

Go to the other end of your figure and fold the two diagonal creases under to form a triangular shape. Pick up the figure and do a valley fold, folding the entire figure in half down the middle where the two sides of the paper come together, keeping the small folds that you just made on top.
Step 2

Take the short side of the figure and from its long point fold up on it to form another small triangle whose point sticks out about a centimeter beyond the edge of the figure and crease it. Fold it to the opposite side also and crease it and open it back up.
Step 3

Push the end point where you just made the folds up through the middle of the figure along the creases you just made to create an inverse fold. Then push the sides of the figure in to crease.
Step 4

Fold two-thirds of the figure over the end that looks like bunny ears and reverse the fold creasing it on both sides and opening it back up. Go about a third of the way down the figure and make a parallel fold, creasing it both ways and opening it back up.
Step 5

Open up the figure and grasping the right end with your index finger inside of the inverse fold you just made, push the right end toward the left so it folds under the left side along the creases you just made. It will make the neck of the sphinx shorter.
Step 6

Take the small point on top, which is the sphinx's nose, and fold the tip of it sideways in each direction and open it back up. Push in on the middle of it to create its flat nose. Set the figure down and admire your completed sphinx.

Friday, November 20, 2009

Astronauts have discovered water on the moon

On October 9,2009, NASA let a spaceship crash into the Moon to see if water is there. NASA thought the spaceship will be covered with dust. But actually,the spaceship was not covered with dust. NASA discovered that by satelites which connected to Earth.They were so suprised. NASA is still trying to know if there's a problem with the satelite or is that what really happened. They also found water there.